Need of ruler and circle!

[calm_joe]

This is a critique:

During centuries people worked with ruler and circles with an exactness on their paper works.

Programms should contain possibilities to draw from a point circles like with a compass and ruler, ...

Designers of programs without these, do not give credit to productive tools and give up centuries of worked out operating experience.

In fact, I do not know one program, that does have something like a compass.

[Zagna]

If you change Units in the toolbar to inches or centimeters, then with the line tool you can see the exact length of the line and the angle which it's drawn at in the status bar at lower left corner of the window. Also you can check start and end points from lower right.

[calm_joe]

If you change Units in the toolbar to inches or centimeters, then with the line tool you can see the exact length of the line and the angle which it's drawn at in the status bar at lower left corner of the window. Also you can check start and end points from lower right.

Yet it's not the same feeling as handling a ruler and circle.

[calm_joe]

If you change Units in the toolbar to inches or centimeters, then with the line tool you can see the exact length of the line and the angle which it's drawn at in the status bar at lower left corner of the window. Also you can check start and end points from lower right.

Yet it's not the same feeling as handling a ruler and circle.

[Benji2]

whats wrong with P.NETs circle maker? I think its all it can be....

Try holding shift while making a circle with it

[Benji2]

whats wrong with P.NETs circle maker? I think its all it can be....

Try holding shift while making a circle with it